Connecting And Configuring An Ex Series Switch (J-Web Procedure) - Juniper EX2200 Hardware Manual

Connecting and Configuring an EX Series Switch (J-Web Procedure)

Copyright © 2018, Juniper Networks, Inc.
redirected to the new management IP address. If the connection cannot be made, the
J-Web interface displays instructions for starting a J-Web session.
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE: You cannot connect to and perform initial configuration of
EX2200-24T-4G-DC, EX4300-48MP, EX4300-48MP-S switches, and
EX4600 switches using EZSetup procedure from the J-Web interface. For
EX2200-24T-4G-DC switches, you must use EZSetup from the switch console.
For EX4300-48MP, EX4300-48MP-S, and EX4600 switches, you must use
the CLI procedure through the switch console.
This topic describes the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC that you will connect to the switch so that the PC can obtain
an IP address dynamically.
NOTE: Read the following steps before you begin the configuration. You
must complete the initial configuration by using EZSetup within 10 minutes.
The switch exits EZSetup after 10 minutes and reverts to the factory default
configuration, and the PC loses connectivity to the switch.
EX2200 and EX2200-C switch—The LEDs on the network ports on the
front panel blink when the switch is in the initial setup mode.
EX3200, EX3300, EX4200, EX4300 switches except EX4300-48MP and
EX4300-48MP-S switches, EX4500, EX4550, EX6200, or EX8200
switch—The LCD panel displays a count-down timer when the switch is in
initial setup mode.
NOTE:
EX4300-48MP-S switches.
Chapter 3: Initial Installation and Configuration
There is no LCD panel on EX4300-48MP and
117