Configuring The Ip Options - Juniper EX2200 Hardware Manual

Network Interfaces for EX4300 Switches

Configuring the IP Options

Related
Documentation
34
NOTE: On EX4300 switches, the interfaces operate in full duplex mode only.
To configure the link mode and speed settings for a 1-Gigabit, 10-Gigabit, or 40-Gigabit
Ethernet interface:
[edit]
user@switch# set interfaces interface-name
To configure additional link settings for a 1-Gigabit, 10-Gigabit, or 40-Gigabit Ethernet
interface:
[edit]
user@switch# set interfaces interface-name ether-options
For detailed information about the FPC, PIC, and port numbers used for EX Series switches,
see "Understanding Interface Naming Conventions on EX Series Switches" on page
Configurable link settings include:
—Specify an aggregated Ethernet bundle. See
802.3ad
Links (CLI Procedure)" on page
—Enable or disable autonegotation of flow control, link mode, and
auto-negotiation
speed.
—Enable or disable flow control.
flow-control
—Specify full duplex, half duplex, or autonegotiation. On EX4300 switches,
link-mode
the interfaces operate in full duplex mode only.
—Enable or disable loopback mode.
loopback
—Specify 10 Mbps, 100 Mbps, 1 Gbps, or autonegotiation.
speed
To specify an IP address for the logical unit using IPv4:
[edit]
user@switch# set interfaces interface-name unit logical-unit-number family inet address ip-address
To specify an IP address for the logical unit using IPv6:
[edit]
user@switch# set interfaces interface-name unit logical-unit-number family inet6 address
ip-address
NOTE: Access interfaces on EX4300 switches are set to
ethernet-switching
user-configured family setting before changing the setting to
.
family inet6
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 35
Monitoring Interface Status and Traffic on page 233
"Configuring Aggregated Ethernet
82.
by default. You might have to delete this or any other
Copyright © 2015, Juniper Networks, Inc.
6.
family
family inet or