Primary (Address On Interface) - Juniper EX2200 Hardware Manual

primary (Address on Interface)

Syntax
Hierarchy Level
Release Information
Description
Default
Required Privilege
Level
Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
primary;
[edit interfaces interface-name unit logical-unit-number family family address address],
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number
family family address address]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 11.1 for the QFX Series.
Configure this address to be the primary address of the protocol on the interface. If the
logical unit has more than one address, the primary address is used by default as the
source address when packet transfer originates from the interface and the destination
address does not indicate the subnet.
NOTE: The edit logical-systems
For unicast traffic, the primary address is the lowest non-127 (in other words,
non-loopback) preferred address on the unit.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Configuring the Interface Address on page 48
Chapter 3: Configuration Statements
hierarchy is not available on QFabric systems.
217