Table 11: Port Edit Options - Juniper EX2200 Hardware Manual

Table 11: Port Edit Options

Field Function
Port Role Options
Port Role Specifies a profile (role) to assign to the interface.
NOTE: After a port role is configured on the
interface, you cannot specify VLAN options or IP
options.
NOTE: Port roles are not supported by the et
interfaces (40-Gigabit Ethernet interfaces) on
EX4300 switches.
NOTE: Only the following port roles can be applied
on EX8200 switch interfaces:
Default
Layer 2 uplink
Routed uplink
Default Applies the default role.
The interface family is set to
port mode is set to
Desktop Applies the desktop role.
The interface family is set to
port mode is set to
the and
edge
security parameters (MAC limit =1; dynamic ARP
inspection and DHCP snooping enabled) are set.
Desktop and Applies the desktop and phone role.
Phone
The interface family is set to
port mode is set to
parameters (MAC limit =1; dynamic ARP Inspection
and DHCP snooping enabled) are set, and
recommended class-of-service (CoS) parameters
are specified for forwarding classes, schedulers,
and classifiers. See
CoS information.
Wireless Applies the wireless access point role.
Access Point
The interface family is set to
port mode is set to
with the
edge
Copyright © 2015, Juniper Networks, Inc.
ethernet-switching
, and RSTP is enabled.
access
ethernet-switching
, RSTP is enabled with
access
options, and port
point-to-point
ethernet-switching
, port security
access
Table 12 on page 40 for more
ethernet-switching
access , and RSTP is enabled
and options.
point-to-point
Your Action
1. Click to view CLI commands for this role.
Details
2. Click .
OK
,
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface.
2. Click to view CLI commands for this role.
Details
3. Click .
OK
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface.
You can also select an existing VoIP VLAN
configuration or a new VoIP VLAN configuration to
be associated with the interface.
NOTE: VoIP is not supported on EX8200 switches.
2. Click Details to view CLI commands for this role.
3. Click .
OK
1. Select an existing VLAN configuration or type the
name of a new VLAN configuration to be associated
,
with the interface. Type the VLAN ID for a new VLAN.
2. Click to view CLI commands for this role.
Details
3. Click OK .
Chapter 2: Configuration Tasks
37