Juniper EX2200 Hardware Manual page 336

Network Interfaces for EX4300 Switches
Table 52: show interfaces xe- Output Fields (continued)
Field Name Field Description
Route table in which the logical interface address is located. For example,
Route Table
refers to the routing table
Names of any input filters applied to this interface.
Input Filters
Names of any output filters applied to this interface.
Output Filters
Information about protocol family flags.
Flags
If unicast reverse-path forwarding (RPF) is explicitly configured on the specified
interface, the uRPF flag is displayed. If unicast RPF was configured on a different
interface (and therefore is enabled on all switch interfaces) but was not explicitly
configured on the specified interface, the uRPF flag is not displayed even though
unicast RPF is enabled.
Information about the address flags.
Addresses, Flags
Protocol family configured on the logical interface. If the protocol is
protocol-family
address of the interface is also displayed.
Information about the address flags.
Flags
IP address of the remote side of the connection.
Destination
IP address of the logical interface.
Local
Broadcast address of the logical interlace.
Broadcast
Unique number for use by Juniper Networks technical support only.
Generation
Sample Output
show interfaces xe-4/1/0
316
.
inet.0
user@switch show interfaces xe-4/1/0
Physical interface: xe-4/1/0, Enabled, Physical link is Up
Interface index: 387, SNMP ifIndex: 369
Level of Output
0 detail
extensive
none
detail
extensive
detail
extensive
detail
extensive
detail
extensive
none
, the IP
inet brief
detail
extensive
none
detail
extensive
none
detail
extensive
none
detail
extensive
none
detail
extensive
Copyright © 2015, Juniper Networks, Inc.