Configuring Energy Efficient Ethernet On Interfaces (Cli Procedure); Enabling Eee On An Eee-Capable Base-T Copper Ethernet Port; Disabling Eee On A Base-T Copper Ethernet Port - Juniper EX2200 Hardware Manual

Related
Documentation

Configuring Energy Efficient Ethernet on Interfaces (CLI Procedure)

Enabling EEE on an EEE-Capable Base-T Copper Ethernet Port

Disabling EEE on a Base-T Copper Ethernet Port

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
On EX8200 switches, the range of valid values for
When the maximum value (12) is specified, all configured links of a bundle must be up
for the bundle to be labeled
If the number of links configured in an aggregated Ethernet interface is less than the
minimum link value configured under the
configuration commit fails and an error message is displayed.
aggregated-ether-options
minimum-links
Ethernet Interfaces
Energy Efficient Ethernet (EEE), an Institute of Electrical and Electronics Engineers (IEEE)
802.3az standard, reduces the power consumption of physical layer devices (PHYs)
during periods of low link utilization. EEE saves energy by putting part of the transmission
circuit into low power mode when a link is idle.
NOTE: Configure EEE only on EEE-capable Base-T copper Ethernet ports. If
you configure EEE on unsupported ports, the console displays the message:
"EEE not supported"
This topic describes:
Enabling EEE on an EEE-Capable Base-T Copper Ethernet Port on page 93
Disabling EEE on a Base-T Copper Ethernet Port on page 93
To enable EEE on an EEE-capable Base-T copper Ethernet interface:
[edit]
user@switch# set interfaces interface-name ether-options
You can view the EEE status by using the
To disable EEE on a Base-T copper Ethernet interface:
[edit]
user@switch# delete interfaces interface-name ether-options
By default, EEE is disabled on EEE-capable ports.
Verifying That EEE Is Saving Energy on Configured Ports on page 235
Understanding How Energy Efficient Ethernet Reduces Power Consumption on
Interfaces on page 16
minimum-links number
.
up
aggregated-ether-options
.
show interfaces interface-name detail
Chapter 2: Configuration Tasks
is 1 through 12.
statement, the
ieee-802-3az-eee
command.
ieee-802-3az-eee
93