Xfp Uplink Module; Chassis Status Leds In Ex4200 Switches - Juniper EX4200 Hardware Manual

XFP Uplink Module

Figure 8 on page 37 shows the XFP uplink module, which provides two ports for 10-gigabit XFP transceivers.
Figure 8: XFP Uplink Module
Port 0
XFP uplink modules are shipped with a dust cover preinstalled in one port.
The XFP uplink module requires Junos OS for EX Series switches, Release 9.0 or later.
SEE ALSO
Example: Configuring Aggregated Ethernet High-Speed Uplinks Between an EX4200 Virtual Chassis Access
Switch and an EX4200 Virtual Chassis Distribution Switch
Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between an EX4200 Virtual
Chassis Access Switch and an EX4200 Virtual Chassis Distribution Switch
Troubleshooting Virtual Chassis Port Connectivity on an EX4200 Switch | 247

Chassis Status LEDs in EX4200 Switches

The front panel of an EX4200 switch has three LEDs on the far right side of the panel, next to the LCD
panel (see Figure 9 on page
Status LED Status LED
Port 1
Link/Activity Link/Activity
LED LED
38).
37