Bank Angle Sensor - Honda 2006 TRX680FA Service Manual

BANK ANGLE SENSOR
INSPECTION
FUEL SYSTEM (PGM-FII
Remove the right inner fende r (page 3-9),
Disconnect the bank angle senso r 3P (Green ) con -
nect or and co nnect the inspection test harness.
Turn the ignitio n swi tch ON and engine stop switch
to "()".
M easur e th e vo ltage betwe en the lest harness ItH-
minals.
TOOL:
Inspection test harness
~ C O N N ECTI ON
W hite C ;:r=
R edl':Jl c --
Redl +l -
G reen(~) --
07GMJ- Ml B0100
STANDARD
- Batt ery vol tage
0- lV
j
INSPECTION TEST HARNESS
Do
nOI
d,sco!>l1ecr
tilt!
bank ang!e
sensor connector
dwmy
Illsflflr.tmn
Beloft> you ppr-
1 01m thIs
I~sr.
tum
tha
"<I"ll'on
SWII,h
OFF, then tum rho
,gll!flan sWifch ON
eea engme stop
SWItch
O'
Turn the ign ition sw itch OFF.
Rem ove t he ri ght bolt and loosen t he left bolt.
Remove the bank angle senso r from left side of
grommet.
Connect t he bank angle sensor 3P (Green ) conncc.
to r.
Place th e bank angle senso r is no rma l position as
shown, and ig nit io n switch ON and engine stop
sw itch "0", bank angle senso r is norma l if the
eng ine stop re lay cl icks and power supply is closed.
Incl ine t he ban k ang le sensor app roximately
70'
t o
the left or r ig ht w ith keep t he ignition switc h ON and
engi ne sto p sw itch "0" t he ban k angle sensor is no r-
ma l if the eng ine stop relay cl icks and power supp ly
is ope n.
REMOVAl/lNSTAlLATION
NORMAL
POSITION
70 ' (approximately)
o
10' (ap pro xi mate ly)
Remov e the rig ht inner fend er {page 3-9).
Disconnect t he bank angle sensor 3P IG reenl con-
nector.
6-51