14 -
2-Pen Assignment (Switching the
3
Tools)
Attaching to Tool Holder
The 2-pen unit is a factory-installed option. It cannot be retrofitted.
Operation
1
Loosen the tool holder screw.
2
While pushing the tool holder in the upward direction, push the
tool all the way into the holder until its flange contacts the upper
part of the holder.
Upper part of
tool holder
Next page
Flange
For half cutting
(backward)
For cutting out
(forward)
14-7
Supplement
See "Attaching a Tool"
P.2-4
tighten the screws on the tool holder.
CAUTION
When pushing the tool holder with your fingers,
the blade tip may be protruding. Take care not to
cut your fingers.
Supplement
The forward position of the tool is used for the
l
cutting out mainly, and the backward position is
used for the half cutting mainly.
Cutting out means that the media is cut out
l
completely.
Half cutting means that only the marking film is
l
cut out, leaving the backing sheet uncut.
See "What is Cutting Plotter?" in Setup Manual
l
for structure of the marking film.
for how to