External Delivery Sensor; Removing The Outside Delivery Sensor; Fixing Inlet Sensor; Removing The Fixing Inlet Sensor - Canon iR6570 series Service Manual

9.5.14 External Delivery Sensor

9.5.14.1 Removing the Outside Delivery Sensor

1) Remove the fixing feeding unit from the machine.
2) Remove the outside delivery roller.
3) Remove the 2 screws [1], and pull out the sensor support plate toward
the outside.
4) Disconnect the connector [1], and detach the outside delivery jam
sensor [2] from the sensor support plate.

9.5.15 Internal Delivery Sensor

9.5.15.1 Removing the Inside Delivery Sensor

1) Remove the inside delivery roller.
2) Remove the screw [1], and remove the protrusion [2]; then, pull out
the sensor support plate [3] toward the outside.
[2] [1]
F-9-122
0009-4848
[1]
[2]
F-9-123
[2] [1]
F-9-124
0009-4878
[1]
3) Disconnect the connector [1], and detach the inside delivery sensor
[2] from the sensor support plate [2].
[1]

9.5.16 Fixing Inlet Sensor

9.5.16.1 Removing the Fixing Inlet Sensor

1) Slide out the fixing feeding unit.
2) Check the position (front, rear) of the fixing inlet guide base. (Locate
the marking line [1] of the fixing inlet guide base in relation to the
indexes [3] of the height adjusting support plate.
Thereafter, remove the 2 screws [3], and disconnect the connector [4];
then, detach the fixing inlet guide base [5].
Chapter 9
[3] [2]
F-9-125
[2]
F-9-126
0009-4866
9-41