Canon iR6570 series Service Manual page 610

Chapter 16
Sub-item
SENS-CNF
RAW-DATA
SHARP
LAPC-SW
FDW-DLV
COTDPC-D
EVL-VDT
RMT-LANG
HI-HUME
IFAX-LIM
DF-BLINE
DRM-H-SW
SMTPTXPN
SMTPRXPN
POP3PN
RUI-DSP
ORG-LGL
16-42
COPIER > OPTION > BODY
Description
Use it to set the arrangement of original sensors.
setting
0: AB (default)
1: inch
2: A
Use it to specify how received data should be printed.
If a received image has a fault, use this mode to find out if the fault is in the
data or in image processing.
setting
0: normal operation (default)
1: print as is
Use it to change the level of sharpness (median value).
setting: 1 to 5
Use it to switch over laser APC correction.
0: execute initial rotation APC if left alone for 10 min
1: execute initial rotation APC if left alone for 60 min (default)
2: execute initial rotation if left alone for 120 min
3: disable initial rotation APC only
4: disable
Use it to select face-up delivery or face-down delivery when the count is set
to multiple.
setting
0: normal (for a single original, face-up for all; default)
1: for a single original, face-up delivery if the count is set to '1'; otherwise,
face-down
This item is for use at the factory.
setting: 0 to 3 (default: 0)
Use it to switch over drum target potential to suit the environment of the site.
setting: 0 to 6 (default: 1)
Use it to change the language for the remote UI to be used through the Web
browser.
Select the particular language using the + and - keys.
Use it to change the developing bias frequency.
If a separation fault occurs in a high humidity environment, set it to '1'.
setting
0: 2700 Hz (default); 1: 200 Hz
Use it to limit the number of output lines if an excess volume of data is
received through i-fax.
setting: 0 to 999 (default: 500)
0: no limit
Use it execute a remedial measure in response to black lines caused by dust
on the platen roller when the ADF is use (stream reading mode).
setting
0: disable (default)
1: enable
Use it to enable/disable the nighttime drum heater.
0: enable drum heater
1: turn on/off drum heater in keeping with environment (default)
2: disable drum heater
Use it to change the SMTP transmission port number.
setting: 0 to 65535
Use it to change the SMTP transmission port number.
setting: 0 to 65535
Use it to change the POP reception port number.
setting: 0 to 65535
Use it to enable/disable a remote IU function (designed for the Disabilities
Act).
setting
0: do not show Copier screen on remote UI (default)
1: show Copier screen
Use it set a special paper size that the ADF cannot recognize (applicable to
LGL communicated by the ADF).
setting
0: LGL (default)
1: FOOLSCAP
2: A-FOOLSCAP
3: FORIO
4: G-LEGAL
5: OFFICIO
6: E-OFFICIO
7: A-OFFICIO
8: B-OFFICIO
9: A-LEGAL
10: M-OFFICIO
Level
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2