Feeder; Feeder List - Canon iR6570 series Service Manual

Chapter 16
Sub-item
HD-CHECK
HD-CLEAR

16.5.2 FEEDER

16.5.2.1 FEEDER List

Sub-item
SENS-INT
MTR-CHK
TRY-A4
TRY-A5R
TRY-LTR
TRY-LTRR
FEED-CHK
CL-CHK
CL-ON
16-38
COPIER > FUNCTION > SYSTEM
Description
Use it to check and recover the partition you have selected using CHK-
TYPE.
procedure
1) Select the item.
2) Press the OK key.
3) See the result. (1: OK; 2: NG (hardware); 3: NG (software) (recovery
sector/substitute sector also indicated))
Use it to initialize the partition you have selected using CHK-TYPE.
Procedure
1) Select the item.
2) Press the OK key.
T-16-50
COPIER > FEEDER > FUNCTION
Description
Use it to adjust the sensitivity of individual sensors of the ADF.
Be sure to clean the sensor area before executing the item.
Procedure
1) Select the item, and press the OK key.
2) See that the execution ends automatically.
Use it to check the ADF motor on its own.
Procedure
1) Press MTR-CHK to highlight.
2) Type in the appropriate motor number using the keypad.
3) Press the OK key.
4) Press MTR-on to start the check.
Motor Number
0: pickup motor
1: feed motor
Use it to execute automatic adjustment of paper width detection reference
point 1 of the ADF original pickup tray. (A4)
Use it to execute automatic adjustment of paper width detection reference
print 2 of the ADF original pickup tray. (A5R)
Use it to execute automatic adjustment of paper width detection reference
point 1 of the ADF original pickup tray. (LTR)
Use it to execute automatic adjustment of paper width detection reference
point 2 of the ADF original pickup tray. (LTRR)
Use it to check paper movement in the ADF on its own.
Procedure
1) Press FEED-CHK to highlight.
2) Type in the appropriate paper feed mode using the keypad.
3) Press the OK key.
4) Press FEED-on to check the operation.
Paper Feed Mode Number
0: simplex pickup delivery
1: duplex pickup delivery operation
2: simplex pickup delivery operation (w/ stamp)
3: duplex pickup delivery operation (w/ stamp)
Use it to check the ADF clutch on its own.
Procedure
1) Press CL-CHK to highlight.
2) Type in the appropriate clutch number.
3) Press the OK key.
4) Press CL-on to check the operation.
Clutch Number
0: pickup clutch
Use it to start the operation of the clutch.
Procedure
1) Press CL-on and then the OK key to start the operation of the clutch.
2) Press the OK key once again to stop the operation. (The operation will
stop automatically in about 2 sec; however, the indication will not change
to 'STOP' unless you press the OK key.)
Level
1
1
0009-6356
Level
1
1
1
1
1
1
1
1
1