Canon iR6570 series Service Manual page 604

Chapter 16
Sub-item
OPTION
MMI
MN-CON
CARD
ALARM
SND-STUP
CA-KEY
<MISC-R>
Sub-item
SCANLAMP
<MISC-P>
Sub-item
P-PRINT
16-36
COPIER > FUNCTION > CLEAR
Description
Use it to reset the service mode setting OPTION to its default setting (as upon
RAM initialization).
The setting will be initialized when the OK key is pressed.
The execution of this item will reset the data kept by the main controller, DC
controller, and reader controller.
Procedure
1) Print out the service mode particulars using the following:
COPIER>FUTON>MISC-P>P-PRINT.
2) Select the item, and press the OK key.
Use it to reset the following settings of user mode:
- backup user data for copier control panel (user settings)
- common settings backup data (user settings)
- various backup data except FAX data (sure settings)
The settings will be initialized when the main power switch is turned off and
then back on.
Procedure
1) Select the item, and press the OK key.
2) Turn off and then back on the main power.
Use it reset the RAM on the main controller PCB.
The RAM will be reset when the main power switch is turned off and then back
on.
Procedure
1) Print out the service mode particulars using the following:
COPIER>FUNCTION>MISC-P>P-PRINT.
2) Select the item, and press the OK key.
3) Turn off and then back on the main power.
4) As necessary, enter the data you have printed out using P-PRINT.
Use it to reset the data related to card ID (group).
The card ID-related data will be reset when the main power switch is turned off
and then back on.
Procedure
1) Select the item, and press the OK key.
2) Turn off and then back on the main power.
Use it to reset the alarm log.
The alarm log will be reset when the main power switch is turned off and the
back on.
Procedure
1) Select the item, and press the OK key.
2) Turn off and then back on the main power.
Use it to reset the transmission read settings.
The transmission read settings will be reset when the main power switch is
turned off and then back on.
Procedure
1) Select the item, and press the OK key.
2) Turn off and then back on the main power.
Use it to reset the CA certificate and key.
The CA certificate and the key will be reset when the main power switch is
turned off and then back on.
Procedure
1) Select the item, and press the OK key.
2) Turn off and then back on the main power.
T-16-46
COPIER > FUNCTION > MISC-R
Description
Use it to turn on the scanning lamp.
Procedure
1) Select the item.
2) Press the OK key so that the scanning lamp goes on and remains on for 3 sec.
T-16-47
COPIER > FUNCTION > MISC-P
Description
Use it to print out service mode settings.
Procedure
1) Select the item.
2) Press the OK key to generate a printout.
Level
1
1
1
1
1
2
2
Level
1
Level
1