Fixing Inlet Guide Solenoid; Removing The Fixing Inlet Guide Solenoid (Sl1); Adjusting The Position Of The Fixing Inlet Guide Solenoid (Sl1) - Canon iR6570 series Service Manual

1) Slide out the fixing feeding unit.
2) Remove the fixing front cover.
3) Remove the fixing drive assembly.
4) Free the harness from the harness guide [1], disconnect the connector
[2], and remove the 2 screws [3]; then, detach the shutter motor [4].
[3]

9.5.20 Fixing Inlet Guide Solenoid

9.5.20.1 Removing the Fixing Inlet Guide Solenoid (SL1)

1) Slide out the fixing feeding unit.
2) Remove the fixing right, left, and front covers.
3) Disconnect the connector [1], and remove the screw [2]; then, free the
harness from the clamp of the harness support plate [3].
[1]
[2]
4) Remove the 2 screws [1], and detach the fixing feeding unit releasing
lever support plate [2].
[1]
[4] [2]
F-9-133
0009-4867
[3]
[3]
F-9-134
[1]
5) Remove the 2 screws [1], and detach the solenoid [2].
[1]
9.5.20.2 Adjusting the Position of the Fixing Inlet Guide
Solenoid (SL1)
Turn the screw [1] to adjust the position of the solenoid so that the guide
will be as shown in the figure when the solenoid goes on.
Fixing roller
Pressure roller
Chapter 9
[2]
F-9-135
[2]
F-9-136
0009-4882
[1]
Inlet guide
Solenoid
F-9-137
9-43