Orientation Of The Feeding Roller Of The Deck/Cassette Pickup Assembly; Vertical Path Roller; Removing The Right Deck/ Cassette Pickup Assembly - Canon iR6570 series Service Manual

Chapter 8
left deck pickup assembly
[4] [5]
8.10.20.4 Orientation of the Feeding Roller of the Deck/
Cassette Pickup Assembly
When mounting the feeding roller assembly [1] to the cassette pickup
assembly, be sure that the belt pulley [2] is at the front of the machine.
Check to make sure that the protrusion in the roller plate and the roller
are engaged securely.
front
[2]

8.10.21 Vertical Path Roller

8.10.21.1 Removing the Right Deck/ Cassette Pickup
Assembly
The removal procedure of a right door and a left door is the same. An
illustration makes a right door an example and explains it.
1) Slide out the right deck / cassette3 / cassette4.
2) Open the right upper cover and the right lower cover.
An attempt to remove the pickup assembly without removing the deck
will cause the lifter to get trapped, not holding the pickup assembly from
sliding out.
3) Remove the mounting screw [1], and detach the connector cover [2];
then, disconnect the connector [3].
4) Remove the three mounting screws [4], and detach the pickup
assembly [5].
8-62
[3] [7] [6]
F-8-176
0009-5113
[1]
rear
F-8-177
0009-5123
[4]
[5]
8.10.21.2 Removing the Vertical Path Roller 1
1) Remove the following from the front:
E-ring [1], 1 pc.
bearing [2], 1 pc.
2) Remove the following from the rear:
E-ring [3], 1 pc.
bushing [4], 2 pc.
roller base [5]
blue gear [6]
parallel pin [7]
[6]
[7]
[3]
[4]
3) Remove the guide plate [1], and detach the vertical path roller 1 [2].
[1]
[4]
[2]
[3]
[1]
F-8-178
0009-5124
[4]
[2]
[1]
[5]
F-8-179
[2]
F-8-180