Pressure Roller; Removing The Pressure Roller - Canon iR6570 series Service Manual

Chapter 9
[2]
11) Release the 3 locks of the harness guide [1], and free the harness
from the harness guide; then, disconnect the 6 connectors.
[2]
Be sure to disconnect the connector of the shutter HP sensor. If you try
to detach the fixing upper unit later without first disconnecting the
connector, you can deform the shutter sensor base plate or damage the
connector.
12) Remove the 2 screws [1], ad detach the fixing upper unit [2] in the
direction of the arrow.
9-26
[1] [2]
[2] [3]
F-9-43
[2]
[1]
[2]
[2] [1]
F-9-44
[1]

9.5.3 Pressure Roller

9.5.3.1 Removing the Pressure Roller

1) Remove the fixing upper unit.
2) Remove the lower separation claw unit.
3) Remove the pressure roller assembly [1]. (Temporarily put the
pressure roller assembly aside on paper.)
[1]
4) Remove the 2 E-rings [1] and the 2 bearings [2] from both ends of the
pressure roller assembly.
F-9-45
0009-2880
F-9-46