E602 In Detail - Canon iR6570 series Service Manual

15.2.2 E602 in Detail

<E602-XXYY>
- XX= '00'
XX
00
- XX= '01 to FF'
XX
01
02
03
04
05
06
07
08
09
10
11
FF
YY Description
The HDD is not recognized.
At start-up, the start-up partition
(BOOTDEV) is not found.
01
The system software for the
main CPU is absent.
02
An interrupt has been detected
during writing to BootDevice.
03
XX
CHK-
Partition Description
TYPE
compressed image data
FSTDEV
(e.g., Box)
1 file management table,
IMG_MNG
profile
FSTCDEV job archiving (chasing)
APL_GEN general data
general data (temporary
TMP_GEN
file)
2
TMP_FAX for fax (temporary file)
for PDL spool (temporary
TMP_PSS
file)
3 PDLDEV for PDL spool (e.g., font)
firmware (system, MEAP,
key, certificate, PDF
4 BOOTDEV dictionary, RUI content,
audio
dictionary)
5 APL_MEAP MEAP application
6 APL_SEND address book, filter
Not full check on HDD for
0
identified faulty sector and recovery
T-15-3
Remedy
1. Turn off the power, and check the HDD cable for
disconnection; then, turn the
power back on.
2. Turn on the power, and put your ear or finger against the
HDD to see if the disk inside it is rotating.
3. Replace the HDD.
4. Replace the main controller PCB.
1. Start up in safe mode, and execute full formatting using the
SST; then, re-install
the system software, and turn off and then on the power.
2. Replace the HDD.
1. Turn off the power, and turn it back on while holding down
the 1 and 9 keys.
See that the auto write interrupt sector repair routine starts and
the control panel goes
black.
2. See the progress of operation on the display (at the start, the
upper left cursor
will flash). When the display goes white, turn off and then back
on the power.
3. Start in safe mode, and execute full formatting using the SST.
Then, re-install
the system software, and turn off and then back on the power.
T-15-4
At start-up
1 2 3
Remedy
*1 *5
*9
*3 *8
*1 *5
*2 *6
*4 *7
YY
During operation
11,2 13,2 10,12,14,22,
1 5 23,24
Remedy
*10 *11 *12
Chapter 15
0009-7924
15-13