Checking The Connection To The Network; Overview; Ping Operating Procedure; Checking With Remote Host Address - Canon iR6570 series Service Manual

2.3 Checking the Connection to the Network

2.3.1 Overview

Perform this procedure only when connecting the machine to networks.
If user's network environment is TCP/IP, make sure using Ping that the network settings are properly made.
If user's network environment is IPX/SPX or Apple Talk, you don't need to perform this procedure.

2.3.2 Ping Operating Procedure

1) Select the following service mode COPIER>TEST>NETWORK>PING, and select PING.
2) Enter the IP address using the numeric keys on the control panel, and press OK.
3) Press the start key.
- OK is displayed if Ping succeeds, but NG is displayed if it ends in failure.
<NETWORK> < 1/1 >
PING 0. 0. 0. 0
[1]
+/-
F-2-68
[1] Result (OK/NG)
[2] IP address entry

2.3.3 Checking with Remote Host Address

You can check whether a network connection is available by executing Ping using the remote host address.
Remote host address: IP address of PC connecting to/operating under TCP/IP network environment to which the machine is connected.
1) Tell a system administrator that you will check a network connection using Ping.
2) Ask the system administrator about the remote host address.
3) Enter the remote host address in PING.
4) If OK is displayed, it means that the machine is properly connected to networks.
5) If NG is displayed, it means that the machine is not properly connected to networks. Perform the following troubleshooting.
<READY >
[2]
OK
Chapter 2
0008-8560
0008-8561
0008-8562
2-19