Cassette Pickup Assembly; Removing The Right Deck/ Cassette Pickup Assembly; Cassette Pickup Motor; Removing The Rear Cover (Upper) - Canon iR6570 series Service Manual

- The collar of the pickup roller used at the front of the machine is gold-
colored.
When mounting the pickup roller [1] to the pickup assembly, make
sure that the round marking [2] found on the side of the roller and the
round marking [3] found on the collar (gold-colored) are toward the
front of the machine.
(direction of rotation)
Collar (gold-colored) (front of machine)
[1]
- The collar of the pickup roller used at the rear of the machine is silver-
colored. When mounting the pickup roller [4] to the pickup
assembly, make sure that the round mark-ing [5] found on the side of
the roller is toward the front of the machine while the round marking
on the collar (silver-colored) is toward the rear of the machine.
(direction of rotation)
[5]
Collar (silver-colored) (rear of machine)
[4]

8.10.2 Cassette Pickup Assembly

8.10.2.1 Removing the Right Deck/ Cassette Pickup
Assembly
The removal procedure of a right door and a left door is the same. An
illustration makes a right door an example and explains it.
1) Slide out the right deck / cassette3 / cassette4.
2) Open the right upper cover and the right lower cover.
An attempt to remove the pickup assembly without removing the deck
will cause the lifter to get trapped, not holding the pickup assembly from
sliding out.
3) Remove the mounting screw [1], and detach the connector cover [2];
then, disconnect the connector [3].
4) Remove the three mounting screws [4], and detach the pickup
assembly [5].
[2]
[3]
F-8-57
[6]
F-8-58
0009-5119
[4]
[5]

8.10.3 Cassette Pickup Motor

8.10.3.1 Removing the Rear Cover (upper)

1) Open the cable clamp [1], and free the reader unit communications
cable [2].
[1]
2) Remove the 6 screws [1], and detach the upper rear cover [2].
Chapter 8
[4]
[2]
[3]
[1]
F-8-59
0009-3925
[2]
F-8-60
8-37