Applying Grease After Replacing The Fixing Roller; Adjusting The Nip Width; External Delivery Roller; Removing The Outside Delivery Roller - Canon iR6570 series Service Manual

[1]
[1]

9.5.4.3 Applying Grease After Replacing the Fixing Roller

- Apply about 20 mg of grease (Molykote HP-300; CK-8012) on the
inner [1] and outer [2] surfaces of the bushing until there is a white
coating covering the entire sources. Failure to apply grease will cause
abnormal (squeaking) sound.
- There will likely be adhesion of grease on the ends [1] of the fixing
roller when the bushing is fitted to the roller. Be sure to remove the
adhesion.
F-9-67
0009-4873
[2]
[1]
F-9-68

9.5.4.4 Adjusting the Nip Width

There is no need for adjustment of the nip widh.

9.5.5 External Delivery Roller

9.5.5.1 Removing the Outside Delivery Roller

1) Remove the fixing feed unit from the machine.
2) Remove the 2 screws [1], and detach the delivery roller guide [2].
3) Remove the screw [1], and detach the delivery unit [3].
Chapter 9
[1]
F-9-69
0009-4874
0009-4851
[2]
[1]
F-9-70
9-31