Installing The Pick-Up Assembly; Installing The Deck Pressure Plate; Setting Up The Toner Bottle - Canon iR6570 series Service Manual

Chapter 2
[1]

2.2.7 Installing the Pick-up Assembly

1) Remove the pick-up roller pressure release spacer [1].
When removing the spacer, move it to the right and pull it out lifting the
front side.
[1]
2) Pull out the half of the right deck and the cassette, open the lower right
cover, and remove the pick-up roller pressure release spacers [1] for
the right deck, the third, and the fourth cassette.
Reference:
The spacers are removed by pulling out the half of the deck/cassette
because the spacers are pressured and difficult to be removed if the deck/
cassette remain set.
2-12
[2]
F-2-31
0008-7967
[1]
F-2-32
F-2-33
3) After removing the spacers, close the deck/cassette and the lower
right cover.
4) Attach the door tape of the manual feed tray cover using the screw,
and close the tray cover.

2.2.8 Installing the Deck Pressure Plate

1) Press the release button of the left deck, and pull out the left deck.
2) Mount the deck pressure plate [1] in the package using the RS screw
[2], which is also in the package.
[1]
3) Close the left deck.

2.2.9 Setting Up the Toner Bottle

1) Take out the toner bottle from the packing box.
2) Open the toner supply cover [1], and push down on the lock lever [2].
3) Holding the toner bottle [1] as shown in below, turn the cap [2] to the
direction of the arrow, and remove the cap from the toner bottle.
[1]
F-2-34
0008-8062
[2]
F-2-35
0008-8101
[2]
[1]
F-2-36