Points To Note When Mounting The Inside Delivery Roller; Main Thermistor; Removing The Main Thermistor/Shutter Thermistor - Canon iR6570 series Service Manual

Chapter 9
[3]
[2]
[1]
9.5.6.2 Points to Note When Mounting the Inside Delivery
Roller
- A harness is found on the edge (rear) of the inside delivery roller shaft,
and 2 plastic sheets are attached to protect the harness. When fitting
or removing the inside delivery roller, be sure to take care so that you
will not detach the plastic sheets. If you inadvertently detached them,
be sure to put them back on.
[1]

9.5.7 Main Thermistor

9.5.7.1 Removing the Main Thermistor/Shutter
Thermistor
1) Remove the fixing upper unit.
2) Remove the fixing web.
9-34
[1]
[2]
F-9-81
0009-4964
[2]
F-9-82
0009-2916
3) Remove the screw [1], and pull out the busing [2]; then, detach the
web unit [3].
4) Remove the screw [1], and detach the silicone oil tray [2].
[1]
5) Remove the screw [1], and detach the harness retaining cover [2].
[2]
6) Free the harness for the harness guide assembly [1].
7) Remove the 2 screws [1], and slide the thermistor mounting shaft [2]
to detach it from the bushing.
[3]
[1]
[2]
F-9-83
[2]
F-9-84
[1]
F-9-85
[1]
F-9-86