8) Remove the 2 leaf springs each [1], and detach the shutter thermistor
[2] and the main thermistor [3].
[1]
[2]
[1]
9.5.7.2 Points to Note When Mounting the Thermistor/
Shutter Thermistor
- After mounting the main thermistor [1] and the shutter thermistor [2],
check to be sure that they are parallel and in contact with the fixing
roller. If not, start over the mounting work.
[2]
- Be sure to route the harness of the thermistor as shown, seeing to it that
the harness [1] is outside (rear) of the guide pin [2].
[1]
[2]
F-9-87
[1]
[3]
[1]
F-9-88
0009-2917
[1]
F-9-89
[1]
9.5.8 Sub Thermistor
9.5.8.1 Removing the Sub Thermistor
1) Remove the fixing upper unit.
2) Remove the fixing web.
3) Remove the screw [1], and pull out the bushing [2]; then, detach the
web unit [3].
4) Remove the screw [1], and detach the silicone oil tray [2].
Chapter 9
[2]
[2]
F-9-90
0009-2892
[3]
[1]
[2]
F-9-91
9-35