Canon iR6570 series Service Manual page 601

Sub-item
KEY-CHK
TOUCHCHK
Numbers and Names of Input Keys
<PART-CHK>
Sub-item
CL
CL-ON
MTR
MTR-ON
COPIER > FUNCTION > PANEL
Description
Use it to check the key inputs.
Procedure
1) Select [KEY-CHK] so that the numbers and names of input keys appear.
2) Check a key to check. If normal, its corresponding character will appear
on the touch panel. (See the table.)
3) Select [KEY-CHK] to end the ongoing check.
Use it to adjust the coordinates of the analog touch panel.
Procedure
- Use it to match a specific point of the touch panel and its coordinates on the
LCD.
- If you have replaced the LCD assembly, be sure to execute this service
mode item.
1) Select [TOUCH CHECK] to highlight, and press the OK key.
2) Press the 9 + symbols that appear on the touch panel to make adjustments.
T-16-40
Key Indication on screen
0 to 9,#,* 0 to 9,#,*
Reset RESET
Stop STOP
User mode USER
Start START
Clear CLEAR
ID ID
Help ?
Counter Check BILL
T-16-41
COPIER > FUNCTION > PART-CHK
Description
Use it to select a clutch whose operation you want to check.
(range: 1 to 5)
Procedure
1) Select the item.
2) Using the keypad, type in the code of the clutch.
3) Press the OK key.
4) Press [CL-on] to check the operation.
Use it to start a check on the clutch.
Procedure
1) Select an item, and press the OK key so that the clutch will repeatedly go
on and off as follows: for 0.5 sec, on -> for 10 sec, off -> for 0.5 sec, on ->
for 10 sec, off -> for 0.5 sec, on -> off.
Use it to select the motor whose operation you want to check.
(range: 1 to 30)
Procedure
1) Select the item, and press the OK key so that the motor will repeatedly go
on and off as follows: for 0.5 sec, on -> for 10 sec, off -> for 0.5 sec, on ->
for 10 sec, off -> for 0.5 sec, on -> off.
Use it to start the operation of the motor.
Procedure
1) Select the item, and press the OK key so that the motor will repeatedly go
on and off as follows:
- for 20 sec on -> off
- the hopper stirring motor and horizontal registration motor: for 10 sec, on
-> off
- shift tray motor: stops at front/rear HP
Be sure to remove the toner bottle before checking the operation of the bottle
motor (MTR=22); otherwise, the toner is likely to spill out inside the
machine.
Chapter 16
Level
1
1
Level
1
1
1
1
16-33