Anti-Rush Current Pcb; Hvt Pcb - Canon iR6570 series Service Manual

Chapter 10

10.5.12 Anti-Rush Current PCB

10.5.12.1 Removing the Rear Cover (upper)
1) Open the cable clamp [1], and free the reader unit communications
cable [2].
[1]
2) Remove the 6 screws [1], and detach the upper rear cover [2].
[2]
10.5.12.2 Removing the Rush Current Prevention PCB
1) Disconnect the 27 connectors, and free the harness from the wire
saddle.
2) Remove the 8 screws [1], and detach the DC controller PCB base [2];
then, turn it over.
10-30
0009-3950
[2]
F-10-98
[1]
[1]
F-10-99
0009-3951
[1]
[1]
3) Disconnect the 3 connectors [1], and remove the screw [2]; then,
detach the rush current prevention PCB [4] while releasing the 3 PCB
supports [3].
[3]
[3]

10.5.13 HVT PCB

10.5.13.1 Removing the Rear Cover (lower)
1) Remove the 6 screws [1], and detach the rear cover (lower) [2].
[2]
[1]
[1]
F-10-100
[4]
[1] [2]
F-10-101
0009-3885