An attempt to remove the pickup assembly without removing the deck
will cause the lifter to get trapped, not holding the pickup assembly from
sliding out.
3) Remove the mounting screw [1], and detach the connector cover [2];
then, disconnect the connector [3].
4) Remove the three mounting screws [4], and detach the pickup
assembly [5].
[4]
[5]
8.10.28.2 Removing the Left Deck Pickup Assembly
1) Slide out the left deck.
2) Remove the two screws [1] found on the left and right sides of the left
deck[2]; then, detach the left deck[2].
[1]
3) Open the front cover.
4) Disconnect the connector [1] from inside the machine, and remove
the locking support [2].
[4]
[2]
[3]
[1]
F-8-278
0009-5114
[2]
[1]
F-8-279
[1]
5) Remove the two screws [1], and detach the two pickup fixing plates
[2]; then, detach the left deck pickup assembly [3].
Keep supporting the pickup assembly; otherwise, the pickup assembly
could drop when the fixing plate is removed.
[3]
8.10.28.3 Removing the Separation Roller
1) Remove the two mounting screws [1], and detach the feed guide plate
[2]; then, detach the open/close guide [3].
(Skip this step for the left deck pickup assembly.)
[2]
[1]
2) Remove the two mounting screws [1], and detach the separation roller
assembly [2] form the joint.
(For the left deck pickup assembly, remove one screw [3].)
- Right Deck/ Cassette Pickup Assembly3,4
Chapter 8
[2]
F-8-280
[2] [1]
[1]
[1]
F-8-281
0009-5115
[3]
[1]
F-8-282
8-83