Snmp V3 Trap Receivers Configuration - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™

SNMP v3 Trap Receivers Configuration

Use the Trap Receiver v3 page to configure settings for each SNMPv3 management host (also known as the
SNMP trap receiver) that will receive notifications about traps generated by the device.
To access the Trap Receiver v3 configuration page, click System > Advanced Configuration > SNMP > Trap
Receiver V3 from the navigation menu.
Field
Host IP Address
User Name
Notify Type
Security Level
Timeout Value
Retries
Filter
UDP Port
Use the buttons to perform the following tasks:
• To add an SNMP trap receiver and configure its settings, click Add. In the Add SNMP v3 Host dialog box,
enter the required information, and then click Submit to appy the changes.
• To delete one or more SNMP trap receivers from the list, select each entry to delete and click Remove, and
confirm the deletion.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
SNMP v3 Trap Receivers
SNMP v3 Trap Receivers Fields
Description
The IP address of the SNMP management host that will receive traps generated by the device.
The name of the SNMP user that is authorized to receive the SNMP notification.
The type of SNMP notification to send the SNMP management host:
• Inform An SNMP message notifying the host when a certain event occurs on the device. The SNMP
management host acknowledge the message. This notification type is not available for SNMPv1.
• Trap An SNMP message that notifies the host when a certain event has occurred on the device.
The message is not acknowledged by the SNMP management host.
The security level associated with the SNMP user, which is one of the following:
• No Auth No Priv No authentication and no data encryption (no security).
• Auth No Priv Authentication, but no data encryption. With this security level, users send SNMP
messages that use an MD5 key/password for authentication, but not a DES key/password for encryption.
• Auth Priv Authentication and data encryption. With this security level, users send an MD5
key/password for authentication and a DES key/password for encryption.
The number of seconds to wait for an acknowledgment from the SNMP management host before
resending an inform message.
The number of times to resend an inform message that is not acknowledged by the SNMP
management host.
The name of the filter for the SNMP management host. The filter is configured by using the CLI and
defines which MIB objects to include or exclude from the view. This field is optional.
The UDP port on the SNMP management host that will receive the SNMP notifications. If no value is
specified when configuring a receiver, the default UDP port value is used.
Configuring System Information
75