EdgeSwitch
Administration Guide
™
Chapter 1: Getting Started
This chapter describes how to start the switch and access the user interface. It contains the following
sections:
• "Connecting the Switch to the Network" on page 10
• "Understanding the User Interfaces" on page 10
Connecting the Switch to the Network
For detailed instructions on how to connect the EdgeSwitch to your network, refer to the Quick Start Guide
that came with the switch.
Understanding the User Interfaces
The EdgeSwitch software includes a set of comprehensive management functions for configuring and
monitoring the system using the following methods:
• EdgeSwitch User Interface (UI)
• Command-Line Interface (CLI)
Each of the standards-based management methods allows you to configure and monitor the components
of the EdgeSwitch UI. The method you use to manage the system depends on your network size and
requirements, and on your preference.
This guide describes how to use the EdgeSwitch UI to manage and monitor the system. For information
about how to manage and monitor the system by using the CLI, see the EdgeSwitch CLI Command Reference.
Using the EdgeSwitch UI
This section describes how to use the EdgeSwitch UI.
Accessing the UI
To access the switch using a web browser, the browser must meet the following software requirements:
• HTML version 4.0, or later
• HTTP version 1.1, or later
• JavaScript® version 1.5, or later
Use the following procedures to log into the EdgeSwitch UI:
1. Open a web browser and enter the IP address of the switch in the web browser address field. The login
screen appears, as shown in the following illustration.
2. Type the User Name and Password into the fields on the login screen, and then click Login.
The user name and password are the same as those you use to log on to the command-line interface. By
default, the user name is ubnt, and the password is ubnt. Passwords are case-sensitive.
Ubiquiti Networks, Inc.
EdgeSwitch UI Login Screen
Getting Started
10