File Transfer - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™
Field
IP Address Conflict Currently
Exists
Last Conflicting IP Address
Last Conflicting MAC Address
Time Since Conflict Detected
Use the buttons to perform the following tasks:
• Click Run Detection to activate the IP address conflict detection operation in the system.
• Click Clear History to reset the IP address conflict detection status information that was last seen by the
device.
• Click Refresh to refresh the data on the screen with the present state of the data in the switch.

File Transfer

Use the File Transfer page to upload files from the device to a remote system and to download files from a
remote system to the device.
To access the File Transfer page, click System > Utilities > Transfer in the navigation menu.
Field
Transfer Protocol
Upload
Download
Ubiquiti Networks, Inc.
IP Address Conflict Detection Fields
Description
Indicates whether a conflicting IP address has been detected since this status was last reset.
• False No conflict detected (the subsequent fields on this page display as N/A).
• True Conflict was detected (the subsequent fields on this page show the relevant information).
The device interface IP address that is in conflict. If multiple conflicts were detected, only the most
recent occurrence is displayed.
The MAC address of the remote host associated with the IP address that is in conflict. If multiple
conflicts are detected, only the most recent occurrence is displayed.
The elapsed time (displayed in days, hours, minutes, and seconds) since the last address conflict was
detected, provided that you have not yet clicked Clear History.
File Transfer
File Transfer Fields
Description
The protocol to use to transfer the file. Files can be transferred from the device to a remote system
using TFTP or FTP. Files can be transferred from a remote system to the device using HTTP, TFTP, or FTP.
To transfer a file from the device to a remote system using TFTP or FTP, click
the desired transfer protocol. The File Upload window appears. Configure the information for the file
transfer (described below), and click Begin Transfer to begin the transfer.
To transfer a file from a remote system to the device using HTTP, TFTP or FTP, click
as the desired transfer protocol. The File Download window appears. Configure the information for the
file transfer (described below), and click Begin Transfer to begin the transfer.
Configuring System Information
in the same row as
in the same row
96