Arp Table - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™

ARP Table

Use the ARP Table page to add an entry to the Address Resolution Protocol table.
To display the page, click Routing > ARP Table > Summary in the navigation menu. The ARP Table is
displayed at the bottom of the page, and contains the fields in the table below.
Field
IP Address
MAC Address
Interface
Type
Age
Use the buttons to perform the following tasks:
• To add a static ARP entry, click Add. In the Add Static ARP Entry dialog box, configure the information for
the new ARP entry, and click Submit to apply the changes and save the entry to the ARP table.
• To delete one or more ARP entries, select each entry to delete and click Remove. Note that ARP entries
designated as Local cannot be removed.
• Click Refresh to update the information on the screen with the most current data.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
ARP Table
ARP Table Fields
Description
The IP address of a network host on a subnet attached to one of the device's routing interfaces. When
adding a static ARP entry, specify the IP address for the entry after you click Add.
The unicast MAC address (hardware address) associated with the network host. When adding a static
ARP entry, specify the MAC address to associate with the IP address in the entry.
The routing interface associated with the ARP entry. The network host is associated with the device
through this interface.
The ARP entry type:
Dynamic
• An ARP entry that has been learned by the router
• Gateway A dynamic ARP entry that has the IP address of a routing interface
• Local An ARP entry associated with the MAC address of a routing interface on the device
• Static An ARP entry configured by the user
The age of the entry since it was last learned or refreshed. This value is specified for Dynamic or
Gateway entry types only (it is left blank for all other entry types).
Configuring Routing
189