Diffserv Class Configuration - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™

Diffserv Class Configuration

Use this page to define the criteria to associate with a DiffServ class. As packets are received or transmitted,
these DiffServ classes are used to classify and prioritize packets. Each class can contain multiple match
criteria.
After you select the class to configure from the Class menu, use the buttons to perform the following tasks:
To define criteria for matching packets within a class, click Add Match Criteria. Once you add a match criteria
entry to a class, you cannot edit or remove the entry. However, you can add more match criteria entries to a
class until the maximum number of entries has been reached for the class. This button is not available if the
class type is ACL because the match criteria are defined by the ACL rules.
To remove the associated reference class from the selected class, click Remove Reference Class. Note that
unless the reference class is the last entry in the list of match criteria, the Reference Class match type remains
in the list as a placeholder, but the associated value is N/A, and the previously referenced class is removed.
To display the Diffserv Class Configuration page, click QoS > Diffserv > Class Configuration in the navigation
menu.
Field
Class
Type
Protocol
Match Criteria
Value
Add Match Criteria window – After you click Add Match Criteria, this window opens and allows you to define the match criteria for the
selected class. The window lists the match criteria available for the class. To add match criteria, select the check box associated with
the criteria type. The fields to configure the match values appear after you select the match type. Each match criteria type can be used
only once within a class. If a reference class includes the match criteria type, it cannot be used as an additional match type within the
class, and the match criteria type cannot be selected or configured.
Any
Ubiquiti Networks, Inc.
Diffserv Class Configuration
Diffserv Class Configuration Fields
Description
The name of the class. To configure match criteria for a class, select its name from the menu.
The class type, which is one of the following:
• All All the various match criteria defined for the class should be satisfied for a packet match. All
signifies the logical AND of all the match criteria.
The Layer-3 protocol to use for filtering class types, which is either IPv4 or IPv6.
The type of match criteria defined for the selected class. If the Type is ACL, no information about the
match criteria is available on this page.
The configured value of the match criteria that corresponds to the match type.
Select this option to specify that all packets are considered to match the specified class. There is no
need to configure additional match criteria if Any is selected because a match will occur on all packets.
Configuring Quality of Service
250