Ubiquiti EdgeSwitch ES-24-250W Administration Manual page 55

EdgeSwitch Administration Guide
™
Field
Buffered Log Configuration section:
Admin Mode
Behavior
Command Logger Configuration section:
Admin Mode
Console Log Configuration section:
Admin Mode
Severity Filter
Persistent Log Configuration section:
Admin Mode
Severity Filter
Syslog Configuration section:
Admin Mode
Local UDP Port
Use the buttons to perform the following tasks:
• If you make changes to the page, click Submit to apply the changes to the running configuration.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
Log Configuration Fields
Description
Used to Enable or Disable logging to the buffered (RAM) log file.
Specify what the device should do when the buffered log is full. It can either overwrite the oldest
messages (Wrap) or stop writing new messages to the buffer (Stop on Full).
Used to Enable or Disable logging of the command-line interface (CLI) commands issued on the device.
Used to Enable or Disable logging to any serial device attached to the host.
Select the severity of the messages to be logged. All messages at and above the selected threshold are
logged to the console. The severity can be one of the following:
• Emergency (0) The device is unusable.
• Alert (1) Action must be taken immediately.
Critical (2)
• The device is experiencing primary system failures.
• Error (3) The device is experiencing non-urgent failures.
• Warning (4) The device is experiencing conditions that could lead to system errors if no action is
taken.
• Notice (5) The device is experiencing normal but significant conditions.
• Info (6) The device is providing non-critical information.
• Debug (7) The device is providing debug-level information.
Used to Enable or Disable logging to the persistent log. These messages are not deleted when the
device reboots.
Select the severity of the messages to be logged. All messages at and above the selected threshold
are logged to the console. See the previous severity filter description for more information about each
severity level.
Used to Enable or Disable logging to configured syslog hosts. When the syslog admin mode is disabled
the device does not relay logs to syslog hosts, and no messages will be sent to any collector/relay.
When the syslog admin mode is enabled, messages will be sent to configured collectors/relays using
the values configured for each collector/relay.
The UDP port on the local host from which syslog messages are sent.
Configuring System Information
54