Configuring The Port Mirroring Destination - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™

Configuring the Port Mirroring Destination

1. On the Port Mirroring page, click
The Destination Configuration dialog box opens.
2. Configure the fields shown in the table below.
Field
Type
Remote VLAN
Port
3. Click Submit to save the changes.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Removing Port Mirroring Sources
1. On the Port Mirroring page, select the source port to be removed.
2. Select one or more source ports to remove from the session.
Use the CTRL key to select multiple ports to remove.
3. Click Remove Source, and then click OK to confirm the operation.
The selected source ports are removed from the port mirroring session, and the device is updated.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
next to the Destination field text box.
Multiple Port Mirroring – Add Source Ports Fields
Description
The type of interface to use as the destination:
• None The destination is not configured.
• Remote VLAN Traffic is mirrored to the VLAN on the system that is configured as the RSPAN
VLAN. In an RSPAN configuration, the destination should be the Remote VLAN on any device that
does not have a port connected to the network traffic analyzer.
• Interface Traffic is mirrored to a physical port on the local device. The interface is the probe port
that is connected to a network traffic analyzer.
The VLAN that is configured as the RSPAN VLAN.
Click the drop-down box to select the port to which traffic is mirrored. If the Type is Remote VLAN,
the selected port is a reflector port. The reflector port is a trunk port that carries the mirrored traffic
towards the destination device. If the Type is Interface, the selected port is the probe port that is
connected to a network traffic analyzer.
Configuring System Information
71