Network Port Ipv6 Neighbors - Ubiquiti EdgeSwitch ES-24-250W Administration Manual
User interface for poe switches
Hide thumbs
Also See for EdgeSwitch ES-24-250W:
- Command reference manual (435 pages) ,
- Quick start manual (25 pages) ,
- Quick start manual (25 pages)
Table of Contents
Advertisement
EdgeSwitch
Administration Guide
™
Network Port IPv6 Neighbors
When IPv6 is enabled on the service port, and a ping is initiated to a neighbor, the neighbor is added to the
cache (if successful). The Network Port IPv6 Neighbors page displays data on these ports.
To access this page, click System > Connectivity > IPv6 Neighbors.
Field
IPv6 Address
MAC Address
Type
Is Router
Neighbor State
Last Updated
Use the buttons to perform the following tasks:
• To add a network port static IPv6 neighbor entry, click Add, configure the settings, and click Submit to
apply the changes.
• To remove entries, select each entry to remove, click Remove, and confirm the removal.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
Network Port IPv6 Neighbors
Network Port IPv6 Neighbors Fields
Description
The IPv6 address of a neighbor device that has been reachable on the local link through the network
interface.
The MAC address of the neighboring device.
The type of the neighbor entry, which is one of the following:
•
Static
The neighbor entry is manually configured.
•
Dynamic
The neighbor entry is dynamically resolved.
•
Local
The neighbor entry is a local entry.
•
Other
The neighbor entry is an unknown entry.
Indicates whether the neighbor is a router. The possible values are:
•
True
The neighbor device is a router.
•
False
The neighbor device is not a router.
Specifies the state of the neighbor cache entry. Following are the states for dynamic entries in the IPv6
neighbor discovery cache:
Reachable
•
The neighbor is reachable through the network interface.
•
Stale
The neighbor is not known to be reachable, and the system will begin the process to reach
the neighbor.
•
Delay
The neighbor is not known to be reachable, and upper-layer protocols are attempting to
provide reachability information.
•
Probe
The neighbor is not known to be reachable, and the device is attempting to probe for this
neighbor.
Unknown
•
The reachability status cannot be determined.
The amount of time that has passed since the neighbor entry was last updated.
Configuring System Information
30
Advertisement
Table of Contents
