Ubiquiti EdgeSwitch ES-24-250W Administration Manual page 193

EdgeSwitch Administration Guide
™
Field
ICMP Rate Limit Burst Size
Static Route Preference
Local Route Preference
Maximum Next Hops
Maximum Routes
Global Default Gateway
Use the buttons to perform the following tasks:
• If you make any changes to the page, click Submit to apply the changes to the system.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
Routing IP Configuration Fields (Continued)
Description
To control the ICMP error packets, you can specify the number of ICMP error packets that are allowed
per burst interval. By default, the burst size is 100 packets. When the burst interval is zero, then
configuring this field is not a valid option. The valid burst size range is 1 to 200.
The default distance (preference) for static routes. Lower route-distance values are preferred when
determining the best route. The value configured for Static Route Preference is used when using the CLI
to configure a static route and no preference is specified. Changing the Static Route Preference does
not update the preference of existing static routes.
The default distance (preference) for local routes.
The maximum number of hops supported by the switch. This is a read-only value.
The maximum number of routes (routing table size) supported by the switch.
The IP address of the default gateway for the device. If the destination IP address in a packet does not
match any routes in the routing table, the packet is sent to the default gateway. The gateway specified
in this field is more preferred than a default gateway learned from a DHCP server. Use the buttons next
to this field as follows:
Click this button to configure the default gateway.
Click this button to reset the IP address of the default gateway to the factory default value.
Configuring Routing
192