Snmp-Server V3-Host; Snmptrap Source-Interface - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

snmp-server v3-host

This command configures traps to be sent to the specified host .
Default No default hosts are configured.
snmp-server v3-host host-addr username [traps | informs [timeout seconds]
Format
[retries retries]] [auth | noauth | priv] [udpport port] [filter filter-name]
Mode Global Config
Parameter
host-addr
username
traps
informs
seconds
retries
auth
noauth
priv
port
filter-name

snmptrap source-interface

Use this command in Global Configuration mode to configure the global source-interface (Source IP address) for
all SNMP communication between the SNMP client and the server .
snmptrap source-interface {slot/port | loopback loopback-id|tunnel tunnel-
Format
id|vlan vlan-id}
Mode Global Configuration
Parameter
slot/port
loopback-id
tunnel-id
vlan-id
no snmptrap source-interface
Use this command in Global Configuration mode to remove the global source-interface (Source IP selection) for
all SNMP communication between the SNMP client and the server .
no snmptrap source-interface
Format
Mode Global Configuration
Ubiquiti Networks, Inc.
Definition
The IPv4 or IPv6 address of the host to send the trap or inform to.
User used to send a Trap or Inform message. This user must be associated with a group that supports
the version and access method. The range is 1 to 30 characters.
Send SNMP traps to the host. This is the default option.
Send SNMP informs to the host.
Number of seconds to wait for an acknowledgement before resending the Inform. The default is 15
seconds. The range is 1 to 300 seconds.
Number of times to resend an Inform. The default is 3 attempts. The range is 0 to 255 retries.
Enables authentication but not encryption.
No authentication or encryption. This is the default.
Enables authentication and encryption.
The SNMP Trap receiver port. This value defaults to port 162.
The filter name to associate with this host. Filters can be used to specify which traps are sent to this
host. The range is 1 to 30 characters.
Definition
The unit identifier assigned to the switch.
Configures the loopback interface. The range of the loopback ID is 0 to 7.
Configures the IPv6 tunnel interface. The range of the tunnel ID is 0 to 7.
Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to 4093.
Management Commands
78