Tacacs+ Source Interface Configuration - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™

TACACS+ Source Interface Configuration

Use this page to specify the physical or logical interface to use as the TACACS+ client source interface. When
an IP address is configured on the source interface, this address is used for all TACACS+ communications
between the local TACACS+ client and the remote TACACS+ server. The IP address of the designated source
interface is used in the IP header of TACACS+ management protocol packets. This allows security devices,
such as firewalls, to identify all source packets coming from a specific device.
To access the TACACS+ Source Interface Configuration page, click Security > TACACS+ > Source Interface
Configuration in the navigation menu.
Field
Type
Interface
VLAN ID
Use the buttons to perform the following tasks:
• If you change any settings on this page, click Submit to apply the changes.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
TACACS+ Source Interface Configuration
TACACS+ Source Interface Configuration Fields
Description
The type of interface to use as the source interface:
• None The primary IP address of the originating (outbound) interface is used as the source
address.
• Interface The primary IP address of a physical port is used as the source address.
• VLAN The primary IP address of a VLAN routing interface is used as the source address.
When the selected Type is Interface, select the physical port to use as the source interface.
When the selected Type is VLAN, select the VLAN to use as the source interface. The menu contains
only the VLAN IDs for VLAN routing interfaces.
Managing Device Security
228