EdgeSwitch
Administration Guide
™
LLDP-MED
The Link Layer Discovery Protocol-Media Endpoint Discovery (LLDP-MED) is an enhancement to LLDP that
features:
• Auto-discovery of LAN policies (such as VLAN, Layer-2 Priority and DiffServ settings), enabling plug and
play networking.
• Device location discovery for creation of location databases.
• Extended and automated power management of Power over Ethernet endpoints.
• Inventory management, enabling network administrators to track their network devices and determine
their characteristics (manufacturer, software and hardware versions, serial/asset number).
LLDP-MED Global Configuration
Use the LLDP-MED Global Configuration page to set global parameters for LLDP-MED operation. To display
this page, click Switching > LLDP-MED > Global in the navigation menu.
Field
Fast Start Repeat Count
Device Class
Use the buttons to perform the following tasks:
changes on this page, click Submit
• If you make any
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
LLDP-MED Interface Configuration
Use the LLDP-MED Interface Summary page to enable LLDP-MED mode on an interface and to configure its
properties. To configure the settings for one or more interfaces, select each entry to modify and click Edit.
The same LLDP-MED settings are applied to all selected interfaces.
To display this page, click Switching > LLDP-MED > Interface in the navigation menu.
Ubiquiti Networks, Inc.
LLDP-MED Global Configuration
LLDP-MED Global Configuration Fields
Description
Specifies the number of LLDP-MED Protocol Data Units (PDUs) that will be transmitted when the
protocol is enabled. The range is from 1 to 10. The default value is 3.
Specifies local device's MED Classification. The following three represent the actual endpoints:
•
Class I Generic
(IP Communication Controller etc.)
•
Class II Media
(Conference Bridge etc.)
•
Class III Communication
(IP Telephone etc.)
The fourth device is
Network Connectivity
802.1 bridge, or IEEE 802.11 wireless access point.
Configuring Switching Information
Device, which is typically a LAN switch or router, IEEE
to apply the changes.
182