Protocol Based Auto Voip - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™
• To configure settings on all interfaces, click Edit All. In the Edit OUI Based Port Configuration window,
change the settings as needed, and click Submit to apply the changes.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.

Protocol Based Auto VoIP

Use this page to configure the protocol-based Auto VoIP priority settings and to enable or disable the
protocol-based Auto VoIP mode on the interfaces.
To display the Protocol Based Auto VoIP page, click QoS > Auto VoIP > Protocol Based Auto VoIP in the
navigation menu. A portion of the UI page is shown below.
Field
Auto VoIP VLAN
Prioritization Type
Ubiquiti Networks, Inc.
Protocol Based Auto VoIP
Protocol Based Auto VoIP Fields
Description
The VLAN used to segregate VoIP traffic from other non-voice traffic. All VoIP traffic in a session
identified by the call-control protocol gets assigned to this VoIP VLAN.
The method used to prioritize VoIP traffic when a call-control protocol is detected, which is one of the
following:
• Remark Remark the voice traffic with the specified 802.1p priority value at the ingress interface.
• Traffic Class Assign VoIP traffic to the specified traffic class when egressing the interface.
Configuring Quality of Service
241