User Accounts - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™
Field
Admin Mode
Session Timeout (Minutes)
Maximum Number of Sessions Specifies the maximum number of Telnet sessions that can be connected simultaneously. The
Allow New Sessions
Use the buttons to perform the following tasks:
• If you make changes to the page, click Submit to apply the changes to the running configuration.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.

User Accounts

By default, the switch contains one user account with read/write privileges. This account's default user name
is ubnt and its password is ubnt; both user name and password are case-sensitive.
If you log on to the switch with the default read/write account (ubnt), you can use the User Accounts page
to assign passwords and set security parameters for that account. You can also add up to five additional
accounts (either read-only or read/write). You can delete all accounts except for the default account.
Note: Only a user with read/write privileges may alter data on this screen.
To access the User Accounts page, click System > Users > Accounts in the navigation menu.
Ubiquiti Networks, Inc.
Telnet Session Configuration
Telnet Session Configuration Fields
Description
Used to Enable or Disable the Telnet administrative mode. When enabled, the device may be accessed
through the Telnet port (23). Disabling this mode value disconnects all existing Telnet connections
and shuts down the Telnet port in the device.
Specifies how many minutes (from 1 to 160) a Telnet session can be inactive before it is logged off. The
factory default is 5.
Note: When you change the timeout value, it is immediately applied to all active and inactive sessions.
Any sessions that have been idle longer than the new timeout value are disconnected immediately.
maximum is 4, which is also the factory default.
Select this option to permit new Telnet sessions until the maximum number allowed is reached.
Clear this option to disable new Telnet sessions (but existing sessions are not disconnected).
Configuring System Information
35