Ip Address Conflict Detection - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™
Field
MaxFail
Interval
Port
Size
Source
IP Address
Interface
Status
Results
Use the buttons to perform the following tasks:
• Click Start to initiate the traceroute.
• Click Stop to interrupt the running traceroute.
• Click Refresh to refresh the data on the screen with the present state of the data in the switch.

IP Address Conflict Detection

Use the IP Address Conflict Detection page to determine whether the IP address configured on the device is
the same as the IP address of another device on the same LAN (or on the Internet, for a routable IP address)
and to help you resolve any existing conflicts. An IP address conflict can make both this system and the
system with the same IP address unusable for network operation.
To access the IP Address Conflict Detection page, click System > Utilities > IP Address Conflict in the
navigation menu.
Ubiquiti Networks, Inc.
Traceroute Fields (Continued)
Description
The number of consecutive failures that terminate the traceroute. If the device fails to receive a
response for this number of consecutive probes, the traceroute terminates.
The number of seconds to wait between sending probes.
The UDP destination port number to be used in probe packets. The port number should be a port that
the target host is not listening on, so that when the probe reaches the destination, it responds with an
ICMP Port Unreachable message.
The size of probe payload in bytes.
Select None, IP Address, or Interface as a source.
When the selected Source is IP Address, specify the IP address to use as the source interface.
When the selected Source is Interface, select the physical port to use as the source interface.
The current status of the traceroute, which can be:
• Not Started The traceroute has not been initiated since viewing the page.
In Progress
• The traceroute has been initiated and is running.
• Stopped The traceroute was interrupted by clicking Stop.
• Done The traceroute has completed, and information about the traceroute is displayed in the
Results area.
Displays the results of the traceroute.
IP Address Conflict Detection
Configuring System Information
95