Ubiquiti EdgeSwitch ES-24-250W Administration Manual page 29

EdgeSwitch Administration Guide
™
Field
Network Configuration
Protocol
DHCP Client Identifier
IP Address
Subnet Mask
Default Gateway
MAC Address Type
Burned-In MAC Address
Locally Administered MAC
Address
Management VLAN ID
Ubiquiti Networks, Inc.
IPv4 Network Connectivity
IPv4 Network Connectivity Fields
Description
Specifies what the switch should do following power-up. The factory default is None. Options are as
follows:
• None Do not send any requests following power-up.
Bootp
• Transmit a Bootp request.
• DHCP Transmit a DHCP request.
Click to refresh the DHCP lease.
The DHCP Client Identifier (Option 61) is used by DHCP clients to specify their unique identifier. DHCP
servers use this value to index their database of address bindings. This value must be unique for all
clients in an administrative domain. The Client Identifier string is displayed beside the check box if
DHCP is enabled on the port on which the Client Identifier option is selected (the UI page must be
refreshed after this change is made).
The IP address of the network interface. The factory default value is 0.0.0.0.
Note: Each part of the IP address must start with a number other than zero. For example, IP addresses
001.100.192.6 and 192.001.10.3 are not valid.
The IP subnet mask for the interface. The factory default value is 0.0.0.0.
The default gateway for the IP interface. The factory default value is 0.0.0.0.
Specifies whether to use the burned-in or the locally administered MAC address for in-band
connectivity. The factory default is Burned In.
This read-only field displays the MAC address that is burned-in to the network card at the factory. This
MAC address is used for in-band connectivity if you choose not to configure a locally administered
address.
Specifies a locally administered MAC address for in-band connectivity instead of using the burned-in
universally administered MAC address. In addition to entering an address in this field, you must also
set the MAC address type to locally administered. Enter the address as twelve hexadecimal digits (6
bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0; i.e., byte 0
must have a value between x'40' and x'7F' .
Specifies the management VLAN ID of the switch. It may be configured to any value from 1 to
4093. The management VLAN is used for management of the switch. This field is configurable for
administrative users and read-only for other users.
Configuring System Information
28