Snmp Community Configuration - Ubiquiti EdgeSwitch ES-24-250W Administration Manual

EdgeSwitch Administration Guide
™

SNMP Community Configuration

Access rights are managed by defining communities on the SNMPv1, 2 Community page. When the
community names are changed, access rights are also changed. SNMP Communities are defined only for
SNMP v1 and SNMP v2.
Use the SNMP Community Configuration page to enable SNMP and Authentication notifications. To display
the page, click System > Advanced Configuration > SNMP > Community in the navigation menu.
Field
Community Name
Security Name
Group Name
IP Address
Use the buttons to perform the following tasks:
• To add a community, click Add Community, configure the settings, and click Submit to apply the change.
• To add a community group, click Add Community Group, configure the settings, and click Submit to
apply the change.
• To delete a configured community from the list, select the check box next to its entry, click Remove, and
confirm the deletion.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
SNMP Community Configuration
SNMP Community Configuration Fields
Description
Community name used in SNMPv1/v2 packets. This is configured in the client and identifies the access
the user may connect with.
Identifies the Security entry that associates Communities and Groups for a specific access type.
Identifies the Group associated with this Community entry.
Specifies the IP address that can connect with this community.
Configuring System Information
73