Ubiquiti EdgeSwitch ES-24-250W Administration Manual page 30

EdgeSwitch Administration Guide
™
Field
IPv6 Mode
Network Configuration
Protocol
IPv6 Stateless Address
AutoConfig Mode
DHCPv6 Client DUID
IPv6 Gateway
Static IPv6 Addresses
New IPv6 Address
EUI Flag
Dynamic IPv6 Addresses
Default IPv6 Routers
Use the buttons to perform the following tasks:
• If you change any of the network connectivity parameters, click Submit to apply the settings immediately
to the running configuration.
• Click Refresh to refresh the page with the most current data from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
IPv6 Network Connectivity
IPv6 Network Connectivity Fields
Description
Enables or disables IPv6 mode.
Specifies whether the device should attempt to acquire network information from a DHCPv6 server.
The factory default is None, which disables the DHCPv6 client on the network interface.
Sets the IPv6 stateless address autoconfiguration mode on the network interface.
• Enabled The network interface can acquire an IPv6 address through IPv6 Neighbor Discovery
Protocol (NDP) and the use of Router Advertisement messages.
• Disabled The network interface will not use the native IPv6 address autoconfiguration features to
acquire an IPv6 address.
The client identifier used by DHCPv6 Client when sending messages to the DHCPv6 Server. Displayed
only if IPv6 Network Configuration Protocol is set to DHCP.
The default gateway for the IPv6 network interface. Use the buttons to perform the following:
Click this button to change the field's setting.
Click this button to reset the field to the default value.
The configured static IPv6 addresses. Use the buttons to perform the following:
Click this button to add an IPv6 address by configuring the New IPv6 Address and EUI Flag fields in
the Add IPv6 Address dialog box.
To remove an IPv6 address, select it and then click this button. To remove all IPv6 addresses, click
this button in the heading row.
Specifies the IPv6 address being added.
Sets the EUI flag while configuring a new IPv6 address when selected. The default is option not
selected.
The configured dynamic IPv6 addresses.
The default IPv6 Router address(es).
Configuring System Information
29