Ubiquiti EdgeSwitch ES-24-250W Administration Manual page 101

EdgeSwitch Administration Guide
™
Field
Admin Mode
Persistent Mode
AutoSave Mode
AutoReboot Mode
Retry Count
Status
Use the buttons to perform the following tasks:
• If you change any settings on this page, click Submit to apply the changes.
• To reset the fields to their original values, click Cancel.
• Click Refresh to display the most recently configured AutoInstall state from the switch.
To retain the changes across the switch's next power cycle, click System > Configuration Storage > Save.
Ubiquiti Networks, Inc.
Autoinstall Configuration Fields
Description
The current administrative mode of the AutoInstall feature:
• Start AutoInstall is enabled, and the feature will attempt to automatically configure the device
during the next boot cycle.
• Stop AutoInstall is disabled. The automatic process will begin only if no configuration file is
located during the next boot cycle.
If this option is selected, the settings you configure on this page are automatically saved to persistent
memory in the startup-config file when you apply the changes. If this option is cleared, the device
treats these settings like any other applied changes (i.e., the changes are not retained across a reboot
unless you save the configuration).
If this option is selected, the downloaded configuration is automatically saved to persistent storage. If
this option is cleared, you must explicitly save the downloaded configuration in non-volatile memory
for the configuration to be available for the next reboot.
If this option is selected, the switch automatically reboots after a new image is successfully
downloaded and makes the downloaded image the active image. If this option is cleared, the device
continues to boot with the current image. The downloaded image will not become the active image
until the device reboots.
When attempting to retrieve the DHCP-specified configuration file, this value represents the number
of times the TFTP client on the device tries to use unicast requests before reverting to broadcast
requests.
The current status of the AutoInstall process.
Configuring System Information
100