Adapting the arm rests to the forearm length
Tools:
❒ Allen wrench, size 3
Steps:
1. Loosen the two set screws (three set screws on the control panel side) underneath the arm
rest.
2. Move the arm rest (with the control panel holder or the replacement tube) forward or back
along the attachment rail into the desired position.
Properly reassemble all components upon completion of the work.
figure 57
Adapting the arm rests to the forearm length
6.13.12 Adjusting / Replacing the Clothing Protector
Preparation:
❒ Remove the side panel (see Section 6.13.10).
Tools:
❒ Allen wrench, size 3
Steps:
1. Loosen two Allen head screws on the side panel.
2. Change the position of the clothing protector or remove and replace if required.
Properly reassemble all components upon completion of the work.
60