Retrofitting The Signal Panel Installation Kit; Retrofitting The Rear View Mirror - Otto Bock C2000 Service Instructions Manual

6.21.2 Retrofitting the Signal Panel Installation Kit

The signal panel holder is attached to the back frame using an adapter plate.
Tools:
❒ Allen wrench, size 3
❒ Open-end or combination wrench, size 10
Steps:
1. Attach the holder to the top of the back tube with two screws.
2. Hook the signal panel in place.
Properly reassemble all components upon completion of the work.
figure 104 Installation kit with signal panel

6.21.3 Retrofitting the Rear View Mirror

Tools:
❒ Allen wrench, size 3
Steps:
1. Attach the rear view mirror to the track on the control panel holder.
2. Individually adjust it to user requirements by turning it manually.
Properly reassemble all components upon completion of the work.
figure 105 Retrofitting the rear view mirror
96