Retrofitting The Four-Way Chest Strap (Option For Recaro® Seat Only) - Otto Bock C2000 Service Instructions Manual

6.13.14 Retrofitting the four-Way Chest Strap (Option for Recaro® Seat Only)
The attachment device is located on either side on the rear cross brace under the seat.
Tools:
❒ Screwdriver
❒ Allen wrench, size 4
❒ Hand drill
❒ 4 mm drill bit
Steps:
1. Screw the cross tube to the back of the seat frame.
2. Attach the single strap end to this tube:
a. Spread the two eyelets so they fit over the tube.
b. Insert the screw through the eyelets and bore hole in the centre of the tube and tighten
the screw.
3. Remove the protective cap from the button.
4. Remove the back adjustment button from the back rest.
5. Press out the three small plastic nipples from the rear.
6. Remove the rest of the covering.
7. Of the two holes in the metal plate, bore out the top hole (for the strap mounting screws).
8. Attach both of the other strap ends to these bore holes.
9. Install the covering and adjustment button.
figure 60 Installing / retrofitting the four-way chest strap
62