Retrofitting The Detachable And Swing-Away Control Panel - Otto Bock C2000 Service Instructions Manual

figure 90 Removing the control panel holder

6.19.4 Retrofitting the Detachable and Swing-Away Control Panel

The power wheelchair can be equipped with a removable control panel on a swing-away control
panel holder. For this purpose, the control panel is equipped with a spring steel sheet as a holder.
CAUTION
Risk of injury due to uncontrolled driving characteristics. If the control panel is not fully inserted,
uncontrolled driving characteristics may result. During insertion, ensure that the holder is pushed into
the adapter up to the stop.
Preparation:
❒ Remove the control panel with control panel holder.
Tools:
❒ Phillips screwdriver
❒ Allen wrench, size 3
Steps:
1. Disconnect the control panel plug connection on the controller.
2. Separate the control panel and control panel holder by loosening the four Phillips head
screws on the underside of the control panel holder.
3. Attach the swing-away control panel holder to the underside of the arm rest with three set
screws.
4. Attach the holding plate for the detachable control panel to the underside of the control
panel using four Phillips head screws.
5. Plug on the detachable control panel.
6. Reconnect the plug connection on the controller.
86