6.14.6 Removing the Back Angle Adjustment Actuator
NOTICE
Risk of cable damage. Take note of the cables attached to the seat frame with cable ties. Carefully
cut the cable ties with side-cutting pliers or a knife. Ensure that you do not damage the cables during
this process!
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
❒ Disconnect the back angle adjustment plug connection on the controller or seat module.
Tools:
❒ Allen wrench, size 3
❒ Allen wrench, size 4
Steps:
1. Disconnect the seat function connection cable on the controller or seat module (AAM).
2. Loosing two retaining rings on each of the mounting points at the top and bottom of the
actuator and push out the bolts.
3. Remove the actuator and replace if required.
Properly reassemble all components upon completion of the work.
figure 76
Removing the back angle adjustment actuator
76